Compass Guides



Product Description

The WMT Compass Guides are designed to simplify the layout of arcs on a work piece.  They can be used with a compass, dividers, or a radius inlay cutting tool.  Each guide serves a different purpose as outlined below.  Made from machined aluminum, anodized gray, and laser engraved.  The edge and corner guides work on stock 3/8″ or thicker, thinner boards can be hung over the edge of the bench or shimmed up to provide the necessary clearance.  The sandpaper-backing prevents the guides from slipping around during use.

Compass Edge Guide (CEG):
Large diameter: 1.5″ / Small Diameter: 0.75″
Centers the arc on an edge.
The alignment points can be used to position the tool in a specific location.

Compass Corner Guide (CCG):
Corner diameter: 2.0″ / Overall Dimension: 1.5″ x 1.5″
Centers the arc on a corner.
Can be used on an inner or outer corner.

Compass Surface Guide (CSG):
Diameter: 1.5″
Centers the arc on the surface of a board when you don’t want a deep pin mark on your finished piece.  The four alignment points allow you to locate the tool on a set of cross-hairs.

Additional information

Weight .5 lbs
Dimensions 8 × 2 × 1 in

All 3 Guides, Corner Guide, Edge Guide, Surface Guide